The Dome: 3D Printing and Painting

Share on Facebook0Share on Google+0Tweet about this on TwitterPin on Pinterest0Share on Tumblr0
This is the first part I printed for my BB-8
After a light sanding and two coats of filler primer.
Flat white base coat
Orange paint after masking
After removing the mask

Overall, this was around 30 hours of printing (not including a massive reprint…).  The painting was spread out over the course of a week.

Share on Facebook0Share on Google+0Tweet about this on TwitterPin on Pinterest0Share on Tumblr0

Leave a Reply

Your email address will not be published. Required fields are marked *